Modena EL 2 W, Руководство пользователя

Страница: 7 / 13

7
THE INSTALLATION OF ELECTRIC INSTANT WATER HEATER
1. Determine the installation position of the unit according to the length of power cord / the position of
switch (the distance from the floor to bottom part of the unit should be ≥1.6m).
2. Make sure the distance between the unit and the surrounding wall is not less than 300mm, so that
to have enough space for maintenance purpose.
3. Determine the position of three fixing screws (that is attached with the wrapping carton), make
three holes with corresponding depth to the wall (by means of a drill) and insert a plastic wall
anchor (
fischer ) into the hole.
4. Tighten one of the screws on the top, and make sure that there is the certain distance between the
head of the screw and the wall (see below picture).
5. Install the unit on the wall and tighten two screws at the bottom, connect the wires and re-install
the top cover with the screws.
PLUMBING CONNECTION
1. The water valve with filter should be installed at the water inlet of the unit, and the sealing ring
equipped with filter should be installed at the end face. (See below Figure).
2. Shower flexible tube should be connected with the hot water outlet and the shower head
separately; attached sealing ring should be installed at the end face.
(Pic. 1)