English
18
(Note: All dimensions are in mm)
2.4 Internal Wire Diagram
3.1 Installation Instruction
-
This electrical water heater shall be installed on a solid wall. If the strength of the wall cannot
bear
the load equal to two times of the total weight of the heater filled fully with water, it is
then
necessary to install a special support.
In case of hollow bricks wall, ensure to fill it with cement
concrete completely.
-
After selecting a proper location, install the mounting bracket to a solid wall.
-
Methods of installation: With the condition that the wall is strong enough, drill 2 holes with a
diameter of 8 mm, and the distance between the hole with another hole is 62 mm. Hole depth of
approximately 45mm.Use the anchors and
fasteners provided along with the product for securing
the bracket (Diagram 7) firmly in the wall.
-
Align the slots on the back of the water heater with the projections on the bracket and mount
the
water heater on the bracket. Thereafter slide the water heater gently towards the bottom
side on
lock the water heater.
-
Install the supply socket in the wall. The supply socket be 220V. It is recommended to placed the
socket on the right above the heater. The height of the socket to the ground shall not be less than
1.8m (see Diagram 8). If there is fault on power cable, it should be replaced by MODENA,
agencies or qualified person who is able to do this so as to ensure the safety.
Part 3:
Installation
