Modena BK 1635, Руководство пользователя

Страница: 11 / 24

`
11
INSTALLING THE INDUCTION COOKER ON KITCHEN SET TABLE
To install an induction cooker on the kitchen counter niche, follow these instructions:
The cable is directly plugged into a power supply through a circuit breaker.
ATTENTION
Do not use a power plug, if it is branched/paralleled with other using.
Post the seal adhesive along the sides of the stove's bottom part to
maintain humidity in the bottom area of the induction cooker.
Place the induction cooker on the kitchen counter niche, and use the
available clamp from the induction cooker packaging to fasten the screws.
Make sure all parts have been installed and fastened and plug the stove
power cord into the power outlet.
Connecting the hob to the power supply
The power supply should be connected in compliance with the relevant standard, or a single-pole circuit breaker. The
appliance have a large power rating and must be connected to electricity by MODENA Technician.
Notes:
•
If the cable is damaged or needs replacement, this should be done by MODENA technician using the proper tools, so
as to avoid any accidents.
•
If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must be installed with a
minimum gap of 3mm between the contacts.
•
The installer must ensure that the correct electrical connection has been made and that it complies with safety
regulations.
•
The cable must not be bent or compressed.
•
The cable must be checked regularly and only replaced by MODENA technician.
The method of connections shown below
.