Model Technology Apex 3D EP ARF, Руководство по сборке

Страница: 8 / 24

Page
❑
Set the motor mounting straps and your motor back into place and realign
them.
❑
Place the remaining two motor mounting straps over the motor and secure
the assembly into place, using four M3 x 12mm wood screws.
☞
Tighten the wood screws firmly, yet evenly, to clamp the motor securely
in place.
❑
5 Minute Epoxy
❑
Thick C/A
❑
Modeling Knife
❑
Straight Edge Ruler
❑
Pencil
❑
(1) Wing with Ailerons
❑
(2) Wing Hold-Down Dowels
❑
(1) Wing Hold-Down Doubler
❑
Paper Towels
❑
Rubbing Alcohol
❑
Epoxy Mixing Sticks
❑
Epoxy Mixing Cups
❑
Place the wing hold-down doubler on top of the wing. Align the back
edge of the doubler with the trailing edge of the wing, and align the edges of
the purple covering material on the wing hold-down doubler with the edges
of the purple covering material on the wing.
❑
When satisfied with the alignment, draw an outline around the wing
hold-down doubler on the wing.
STEP 1B: inSTAlling ThE MoToR - BRUShlESS oUTRUnnER DiREcT DRivE
❑
Line up the mounting holes in your motor with the precut slots in the
plywood motor plate.
❑
Secure your motor into place, using the machine screws and washers
included with your motor.
IMPORTANT
The precut slots in the plywood motor plate are 4mm wide. If your motor uses 3mm diameter mounting screws,
you will need to use "oversized" washers to ensure that you can tighten the mounting screws securely. For some motors, it may be
necessary to enlarge the center cutout in the plywood motor plate. Some motors may also include a separate plywood plate that
can be used as a drilling guide. If drilling new holes through the plywood motor plate, make sure to drill the new holes off-center
from the precut slots to ensure adequate strength.
WiNG iNsTALLATiON
YOu'LL NEED THE fOLLOWiNG PArTs frOM THE KiT:
YOu'LL NEED THE fOLLOWiNG TOOLs AND suPPLiEs:
sTEP 1: iNsTALLiNG THE WiNG HOLD-DOWN DOuBLEr