Charging
•
Connect one end of the supplied standard USB cable to the camera.
•
Connect the other end to a USB, 5V DC power source (wall charger, PC or external
battery).
•
When the yellow LED turns on,
press the Power button
for about two seconds to
turn the camera OFF.
When charging, the green LED will be on. It will turn off when the battery is fully charged.
Charging takes about 2-3 hours with the camera turned off and connected to an external
USB Charger. Batteries are not covered under warranty. If charged with under-rated
chargers or by using a USB hub without an additional power supply, expect longer
charging times. For optimum results, the charging voltage should be +5V under load. Only
use quality chargers capable of supplying 1000mA (1A) and a stable voltage of 5V. Low
quality chargers may not be able to supply enough current and can lead to premature
battery failure or, in the worst case, even destroy the camera.
A new and fully charged battery will record up to 110 minutes of 4K 30fps videos and 155
minutes of 1080p 60fps videos.
►
For Dashcam use it is recommended to use a charger or power bank which can supply
at least 2A at a stable 5V.
Automatic Power Off from Standby mode
If the camera is in standby mode you must take a picture(s) or start a video recording
within *30 seconds. The camera will automatically turn off after *30 seconds of no activity.
*This value can be set using any of the setup methods. Automatic Power Off can also
disabled.
When the special A/V cable is connected, automatic power-off will be disabled. This
prevents signal loss during FPV use when the standby time times out.
Recording Video Mode 1 or 2 (yellow or blue LED)
Start video recording.
•
Briefly press the shutter button (top left).
•
►
If the recording LED has been disabled, the yellow or blue LED will slowly blink 3
times and then turn off, indicating that recording has started.
•
►
If the recording LED has been enabled, the yellow or blue LED will slowly flash at
2 second intervals indicating that the camera is recording.
Stop video recording.
•
Briefly press the shutter button (top left). The camera will return to the standby mode
from which the video was started.
