CONTINUED 04. CHANGE OF MOTOR’S OPERATION DIRECTION
Fig. 4
a
b
c
05. SELECTING THE CHANNEL
Channels are selected by means of the buttons located on the
front panel of the remote control. After pressing a button, it is
illuminated and the radio channel is enabled. Channels can be
chosen freely.
Fig. 5.1
CAUTION!
1. Standby mode: pressing the
UPPER AREA
or the
LOWER AREA
on the panel will
only cause the wakeup and the display of the previously ecorded, active channel or
the combination of channels ( no signal will be transmitted ).
2. Standby mode: pressing any of the selection buttons will
wake up the transmitter and cause illumination/activa-
tion of the channel being chosen (then, other channels
can be enabled ).
Fig. 5.2
3. If the
UPPER AREA
or the
LOWER AREA
is not pressed before the transmitter changes
to the standby mode, the newly selected combination of channels will not be saved ( after
waking up the device from the standby mode by pressing the
UPPER AREA
lub
LOWER
AREA
) the previous combination will be used ).
4. Each pressing of the
UPPER AREA
or the
LOWER AREA
in the operating mode will save
the selected channel or the combination of channels in the memory of the device and the
“up” or “down” signal will be sent.
4
Содержание Cosmo|L
Страница 7: ...7 08 NOTES...
