The drive will do two half turns and the operation direction will be changed.
SELECTING THE CHANNEL
Channels are selected by means of the buttons located
on the front panel of the remote control. After pressing a
button, it is illuminated and the radio channel is enabled.
Channels can be chosen freely.
CAUTION!
1. Standby mode: pressing the
UPPER AREA
or the
LOWER AREA
on the panel will only
cause the wakeup and the display of the previously recorded, active channel or the
combination of channels ( no signal will be transmitted ).
2. Standby mode: pressing any of the selection
buttons will wake up the transmitter and cause
illumination/activation of the channel being
chosen (then, other channels can be enabled ).
UPPER AREA
LOWER AREA
3. If the
UPPER AREA
or the
LOWER AREA
is not pressed before the transmitter changes to
the standby mode, the newly selected combination of channels will not be saved ( after
waking up the device from the standby mode by pressing the
UPPER AREA
or the
LOWER
AREA
, the previous combination will be used ).
4. Each pressing of the
UPPER AREA
or the
LOWER AREA
in the operating mode will save the
selected channel or the combination of channels in the memory of the device and the “up”
or “down” signal will be sent.
4
