CAUTION!
Each programming and changing of the motor rotation direction is confirmed by the half
turns of its drive. This is why, the control cannot be programmed when a shutter is in its limit
position – upper or lower. Then, it can be damaged ( e.g. drawn into the housing ).
PROGRAMMING MODE
1.
Connect the power supply.
2. Switch OFF and ON the power supply to the tubular
motor.
3. Switch off and on the power supply to the tubular
motor again. Two half turns of the drive confirm the
programming mode of the motor.
ON OFF
2x
CAUTION!
If no programming action is taken within 20 seconds,
the drive will do two half turns, and the motor will
automatically change to the operating mode – it won’t
be programmed.
> 20 sek.
LOADING THE REMOTE CONTROL INTO THE TUBULAR MOTOR MEMORY
1. Remove the control from its frame as some programming buttons are located on the
back side of the control.
2. Select the right channel ( unless it is a 1-channel control COSMO | L1 ).
3. Press the
STOP
and
UP
buttons (on the back side of the remote control) and hold them
until the drive does two half turns.
1.
2.
3.
2
