CAUTION!
If it is the first remote control loaded into the receiver, this is the MASTER remote control and
the motor will change to the operating mode. Using the MASTER remote control, it is now
possible to operate the motor or program other remote controls. No channel will be loaded by
the motor if the remote control sends signals for several channels simultaneously.
PROGRAMMING THE SECOND REMOTE CONTROL AND EACH SUBSEQUENT ONE
1. Press the
STOP
and
UP
buttons on the
MASTER remote control simultaneously and
hold them for 5 seconds, until the drive does
two half turns confirming the programming
mode of the tubular motor.
MASTER
2. Press simultaneously the
STOP
and
UP
buttons on the second remote control or
on the channel to be programmed (in the
case of the multi-channel remote control)
and hold them until the drive does two
half turns
PILOT X
Another remote control (channel) has been loaded into the motor memory.
The next remote control can be loaded as well. However, if no programming action
is taken within 20 seconds – the motor will automatically change to the operating
mode. This can be also done manually, by means of the MASTER remote control. To set
the operating mode manually, press the
STOP
and
UP
buttons on the MASTER remote
control simultaneously and hold them for more than 5 seconds. In both cases, the
operating mode will be indicated by two half turns of the drive.
CHANGE OF THE MOTOR OPERATION DIRECTION
After loading the remote control in the motor, check if the
STOP
and
DOWN
buttons on
the remote control correspond with rolling the shutter up and down. If not, press the
UP
and
DOWN
buttons on any remote control loaded in the motor simultaneously and hold
them for about 5 seconds.
3
