Mobility Research LiteGait 4Home, Руководство оператора и сервисное руководство

Страница: 13 / 31

13
www.LiteGait.com
1-800-332-9255
14.) To remove post from pallet use
one person to hold the post and
yoke.
13.) Set base over pallet as pictured
with actuator near base.
12.) Prepare base for installation of
actuator. Remove four black steel
bolts from base using allen wrench
in small box.
15.) Locate bolts holding actuator
to pallet. Undo bolts with ½ inch
socket or wrench, loosen actuator
from pallet with one person holding
the actuator steady while loose.
11.) Position base over pallet with
actuator near base as pictured.
16.) Using two people lift the post
onto base.
18.) Insert bolts, hand tighten bolts
(ensure one person holds actuator
steady until secure). Tighten bolts
using 5/16 inch Allen wrench until
snug (do not to over tighten).
19.) Verify operation by moving
actuator up/down by pressing the
arrows on the hand switch. If hand
switch fails to operate the actuator,
check connections at top of the
actuator.
20.) Carefully remove all shrink-
wrap from handle bars yoke and
base
21.) Verify performance of each
locking and directional casters.
17.) Orient the actuator on the base
(the yoke arms and handlebars
point in the same direction as the
base legs). Line up the holes for
bolts to be inserted.
Feel free to call 1-800-332-9255 Extension 7104 for Mobil-
ity Research Support during this assembly.
CAUTION: DO NOT over tighten the
bolts.
NOTE: Your Lite Gait® may look different than images above