MobileView 3008, Руководство по установке

Страница: 37 / 117

Chapter 3: DVR installation
MobileView 3012 Series Installation Manual 31
3) Mount the mounting plate ( ) to the vehicle using four nuts and bolts (not provided) (1/4-
20-inch bolts ( ) are recommended). 1/4-inch spacers ( ) are provided and should be
used beneath the mounting plate, if needed to allow the door to fully open.
4) Place the DVR outer housing back onto the mounting plate by lining up the holes in the
mounting brackets (
) with the bolts in the vibration isolators.
5) Reattach the four acorn nuts and locking washers.
Front Panel
Take a moment to learn where the connections are as the remainder of the
manual will refer to them often.
Figure 27: MobileView 3012 front panel
1. USB 2.0
:
2 ports for connecting USB-Flash-Drive to upload/download
configuration and update system firmware.
2. System Status LEDs: In Normal Operation: The order of the LEDs will
illuminate as follows: PWR, IGN, then REC. These are the three lights that
should be present on a DVR that does not require maintenance.
•
System LED: The SYS light means the DVR is experiencing a system
fault. Possible causes are: Fan Failed, Over Temperature,
Configuration is set for System Faults. If the SYS light turns on the
RED LED on the Tag switch should also illuminate. Verify System
alarms in Web Browser. Login to the web browser on the vehicle.
From the main landing page navigate to Notifications > System Alarms.
•
HDD LED: The HDD light should be off by default indicating that the
system HDD is present and recoding as expected. The HDD light will
turn on if the hard drive caddy is unlocked and or removed.
•
Copy LED: Will turn on only when when you are copying data to USB
(memory stick). Examples include: saving a configuration file or saving
a log file.
H