Mobiak MBK19-PGSGUARD, Инструкция по установке и эксплуатации

Страница: 17 / 24

SOUND MEANING MEASURES
Heat Sensor
4 “beeps” with a 1-second
interval.
Dislocation Alarm
The Heat Sensor is
removed from the
installation plate.
Return the Heat Sensor to the installation plate with the
LED facing the user.
Heat Sensor
Short “beeps” with
5-second intervals.
. . .
Pre-Alarm
The Heat Sensor sounds
an alert to danger
before
disconnecting the cooker.
If the alarm was triggered during normal cooking:
press the Heat Sensor button once while the pre-alarm
sounds. The alarm is turned off and the sensitivity
adjusts slightly.
Heat Sensor
Many quick “beeps” followed
by a long, very loud sound.
. . . ! ! ! !
Switch-off Alarm
The cooker is switched
off.
Make sure that the controls are set to “0”. Press the Heat
Sensor button once to return the power to the cooker.
Control Unit
Short “ring” with 5-second
intervals.
No power
The power to the
cooker has been cut off.
Make sure that the controls are set to "0". Wait until the
cooker has cooled down after it has been disconnected
then press the Heat Sensor button once to return the
power. If the cooker cannot be switched back on, see
FAQ, question 9, page 21.
Control Unit
Continuous "rings".
No power
The cooker is too hot for
the power to be turned
back on.
Make sure that the controls are set to "0". Wait until the
cooker has cooled down and the Control Unit starts emit-
ting a short "ring" with 5-second intervals as described
in the section above, or press the Heat Sensor button
once to reconnect the cooker. If the alarm does not stop,
follow the instructions on page 21, FAQ question 9, and
press again.
Control Unit
Short and long “ring” with
10-second intervals.
No power due to
Auto-diagnostics
Alarm
The cooker has been
disconnected due to a
temporary fault (auto
-
matic error diagnosis).
Make sure that the controls are set to "0". Wait until the
cooker has cooled down after it has been disconnected
then press the Heat Sensor button once to return the
power. If the cooker cannot be switched back on, see
FAQ, question 3, page 20.
Heat Sensor
One “beep” per minute.
Or
Control Unit
One “ring” per minute.
Battery Alarm
The Heat Sensor has a
low battery.
The Heat Sensor battery is low and needs to be replaced.
Pressing the button once at this time delays the alarm
for at least 12 hours.
Action in the event of an alarm
The cooker will automatically be ready for use after the Stove Guard has detected that the hazardous
situation is over, and all the controls are set to “0”. See the alarm overview below for actions.
17
www.mobiak.gr