Mobeye PowerGuard CM4100, Руководство пользователя

Страница: 17 / 32

16
messages can be set between 0 days (no test message) and 30 days. The
default test interval is set to "0" (no test message).
5.3 INPUT TYPE
The input type defines the character of the additional inputs IN1 and IN2.
This can be Normally Open (NO) or Normally Closed (NC). If an input is set
to "NO", the alarm will be triggered as soon as the terminals of the input are
closed. If the input is set to NC, the alarm is triggered when the connection
between the input terminals is broken. The default input type is set to "NO".
It is possible to connect a sensor with an analog output value between 1V
and 48V, by placing a resistor or relay between the sensor and the input. For
an explanation, see the support page on www.mobeye.com.
5.4 ALARM DELAY TIME
The input delay time defines the time that the input is triggered before an
alarm is initiated. If the input returns to the non-alarm status within the delay
time, no alarm is sent. The time can be set between 0 and 999 seconds. As
default, the input delay time is set to 1 second.
5.5 INACTIVE TIME
The “inactive time” defines the time an input is not active after an activation.
During the inactive time, no new alarm message will be sent. Only when the
input returned to the non-alarm status, gets activated again and remains
active, an alarm will be sent yet after the inactive time. If the time is set to
“0”
(minutes), the input will be active again immediately after returning to the
non-alarm status. The time can be set between 0 and 60 minutes. As default,
the inactive time is set to
“0”.
5.6 ALARM REPEAT TIME
In order to emphasize the urgency of the alarm messages, all alarms can be
repeated. As long as the input has not returned to the inactive status, the
textual messages (no phone calls)
will be repeated after the ‘alarm repeat
time’. The r epeat interval can be set between 0 and 24 hours. As default the
alarm repeat time is set to 4 hours.