MOBA R.3CHS, Руководство пользователя

Страница: 14 / 28

14
2.2.1 Bluetooth Communication Setup
The R.ULS.B is normally paired with the DB.UNI.PRO from factory when
the two are bought together. This means that simply switching both on
when near each other is all that is required for establishing communication
between the two. However, in cases where the DB.UNI.PRO is bought at a
later stage or when there is a problem establishing communication, the
following procedure may have to be used to pair the two:
1) Ensure the DB.UNI.PRO and R.ULS.B are near each other.
2) Switch on the R.ULS.B, switch off the DB.UNI.PRO.
3) Press and hold the On/Off button on the DB.UNI.PRO for 10
seconds until a second beep. A progressive LED arrow bar will
begin to flash to indicate the DB.UNI.PRO is in BT configure
mode.
4) After a short period, two LED straight bars will appear on the
start to communicate with the R.ULS.B.
in progress of pairing. After a short period, the DB.UNI.PRO will
being setup and that the instrument is in search mode.
6) If the setup fails at any stage, an X will flash on the DB.UNI.PRO.
Repeat the above steps.
hold the switch button on the R.ULS.B for 5 seconds until all five
lights light up. Repeat steps 2 to 5.
DB.UNI.PRO, flashing in alternate sequence to show the BT is
show the BT is setup and an active device has been found and is
7) If setup fails again, switch off the R.ULS.B and then press and
5) Two LED straight bars will flash together on the DB.UNI.PRO to
© Copyright MOBA Mobile Automation Australia Pty Ltd
Operating the Lasergide
+
12-
Battery
24v
-
R.ULS.B
A.RS.104
A.RS.105
BROWN
OR
TO CIGARETTE
LIGHTER OUTLET
BLUE
DB.UNI.PRO
FINE
WIDE
MED
Bandwidth
Brightness
Power
ON
Figure 5