To ensure a longer battery life fully discharge and charge it several times before using.
Due to variety of car lighter jack sizes depending on the vehicle type, ensure that this unit is properly
connected to the lighter socket.
The unit should be used with the original accessories supplied. The Manufacturer is not responsible for
possible damage of this unit caused by using other accessories than provided by the Manufacturer.
Should this product fail to operate properly, contact your local dealer.
Operations:
Mounting:
Insert the fixing pins on the top of the stand into the bracket holding holes in the bottom of the unit and
move the unit backward until it clicks and is fixed tightly to the bracket.
Press the suction cup to a surface in the car, and then push it along the bar to the windshield. Make
sure the stand is fixed properly to the surface.
You can adjust the angle of the stand by loosening the washer and bending the assembly knot
To unmount the stand, pull it towards you, then lift the plastic ear on the suction cup.
Power and charging:
To charge the battery of this unit connect its USB port to the PC with the supplied USB cable; or connect it to
a car lighter socket with supplied car adapter. The power icon
on the bottom right corner of the display
indicates the remaining power in the battery.
Recording:
Before you start recording, insert a Micro SD memory card into the memory card slot of the unit until
it clicks. Ensure you insert the card correctly.
After the card is inserted, the device will turn off in order to preserve the information. Press POWER
button to turn it on again.
Micro SD capacity supported up to 32 GB, class 4 or higher. For correct
and satisfactory operation, licensed Micro SD memory cards should be used with this unit. Avoid
using memory cards of unknown brands.
Auto recording:
After you connect the unit to car power source, recording will start automatically.
After you disconnect the power source, the unit will continue recording according to the settings.
Manual recording:
Press POWER button to switch on the unit (press and hold it again if you want to
switch off the unit). In recording mode, the top left corner of the display sho ws the camera symbol
indicating that the unit is ready for recording. Press OK button to start recording. Press this button
again to stop recording.
Taking photos:
Press OK button in recording mode to take photos.
While recording, the recording time is shown in white figures in the top right corner of the display. The
unit will save video files automatically after each 1, 2 or 3 minutes (see
“Setup “paragraph below for
more details).
When the memory card is full, old files will be deleted and the ne w files will be recorded instead.
Press OK button to stop and to continue recording.
When the environmental lighting is not bright enough, the unit will automatically activate the LED
lights in the front panel of the unit (if this function is set to Auto
mode; see “Setup “paragraph for more
details).
