Heavy Duty Joystick Installation
Changing the joystick tip
If required, the joystick's tip may be replaced by a custom tip (for example a
'T'.
To remove the default joystick tip, open the rubber cover below the joystick
from the bottom towards the top and use a M12*1.5 wrench to unscrew the
tip.
NOTE:
Replacing the joystick tip is not advised and should only be done
after careful consideration and at your own risk. Contact mo-vis for
more information.
Installing the Heavy Duty Joystick
1
Define the position of the joystick. When the USB connection points
towards the user, a forward movement of the joystick will result in an
according forward movement of the wheelchair. If needed, you can
change this position in steps of 90° with the Configurator Software.
2
Mount the unit with the two included M6*12 bolts at the desired
location. If you use the Heavy Duty Mounting Ring Assembly, see
Duty Mounting Ring Assembly on page 15
.
13
Heavy Duty Joystick Installation Manual 13
