ToolLink User Manual
MKS Instruments, Inc.
Page 5 of 30
0.65
0.45
0.50
0.12
Mtg. Holes
1.225
(2) 0.19 DIA.
1.225
0.725
0.625 DIA. On Case Wall
0.70
1.10
1.25
0.542
3.30
4.30
3.80
CDN466
2
3
5
RXD
TXD
GND
1
2
3
4
5
DRAIN
VDC+
VDC-
CAN H
CAN L
RXD
TXD
GND
2
3
5
RS232
Serial
Device
RS232 Interface
CDN467
1
2
3
DATAA
DATAB
TR
1
2
3
4
5
DRAIN
VDC+
VDC-
CAN H
CAN L
DATAA
DATAB
RS485
Serial
Device
RS485 Interface
120
Connect pins 2 & 3
to terminate cable
CDN466
2
3
5
RXD
TXD
GND
1
2
3
4
5
DRAIN
VDC+
VDC-
CAN H
CAN L
RXD
TXD
GND
2
3
5
RS232
Serial
Device
RS232 Interface, HW Flow Control
7
8
RTS
CTS
RTS
CTS
7
8
INSTALLATION
Mount the ToolLink Gateway on a horizontal or vertical
surface, in a suitable location or enclosure for your
application. Provide sufficient clearance and airflow to
maintain 0°C to 70°C ambient operating temperature
range. Fasten the ToolLink Gateway to the mounting
surface using two screws (not provided) in the 0.19 inch
mounting holes.
WIRING
The ToolLink Gateway requires two connections – one to the
DeviceNet network (male 5-pin micro connector) and one to the
serial device (male DB9 connector). DeviceNet and serial cables
are available from a variety of industrial sources. Follow all
applicable electrical codes in your area when mounting and wiring
any electrical device.
All power is received from the DeviceNet network. The ToolLink
Gateway draws up to 200mA from the 24VDC power supply.
Select your DeviceNet cables and power supply so that it can
provide sufficient current for all networked devices at their peak
operating power.
The following are typical ToolLink Gateway wiring examples. Your
RS232 or RS485 interface may vary. Refer to your device’s
documentation for the required data and control signals.
All dimensions are inches
switch indicator arrow
switch position
switch screw slot
Each rotary switch parameter has a
PGM
option. Setting a
switch to PGM allows the parameter to be remotely set over
DeviceNet. However, it must first be initialized. To initialize,
set the switch to desired value and power up the gateway.
The new settings are saved in its memory. Power down and
change switch to PGM mode.
ROTARY SWITCHES
Set the ToolLink rotary switches to the desired settings. Use
a small slotted screwdriver to rotate the switches. Align the
indicator arrow to the desired setting, as shown below.
