MK Welding Multi-GMAW 200 LCD PFC, Руководство пользователя

Страница: 55 / 104

OPERATION
24
EN
§4.1.6 MIG Torch Liner Installation
(1) Lay the torch out straight on the ground and remove the front end parts.
(2) Remove the liner retaining nut.
(3) Carefully pull the liner out of the torch cable assembly.
(4) Select the correct new liner and carefully unravel avoiding putting any kinks in the liner, if you
kink the liner it will make it no good and will require replacement.
(5) Carefully and slowly feed the liner in short forward movements down the cable assembly all the
way through and out the torch neck end. Avoid kinking the liner, kinking liner it will make it no good
and require replacement.
(6) Fit the liner retaining nut and screw down only 1/2 way .
(7) Leaving the torch straight snip the liner approximately 3mm past the end of the torch neck .
(8) Place the tip holder over the end of the liner and screw into the torch neck nipping it up tight.
(9) Screw down the liner nut the remaining 1/2 and nip it up tight. This method compresses the liner
inside the torch cable assembly preventing it moving during use and ensures good wire feed.
(1) Remove mig torch front end parts. (2) Remove the liner retaining nut.
(3) Carefully pull out and completely remove (4) Carefully unravel the new liner
the liner.