14
(A)
Verify the ON/OFF Switch is in
the OFF position.
MK-1503SS
SETUP
Setup for Operation
1. Velcro Backer Pads may be used for MK Diamond products such as diamond
polishing discs, sandpaper discs, and felt buffing discs. Choose the correct
Backer Pad for the job being performed; rubber Backer Pads for contours
edges, and bullnose surfaces. Rigid Backer Pads for straight edges and
flat surfaces.
2. Located on the top of the gear box is a shaft lock button. Press it to stop shaft
from spinning when installing backer plate. Do not press shaft lock button when
polisher is running.
The indicator light on the GFCI should glow red. The red light should go out when
the TEST button is pressed. This indicates that the GFCI is functioning properly.
Press the RESET to reactivate the GFCI.
NOTE:
NOTE:
(A)
Install the Backer Pad onto the
Spindle (Do not cross-thread)
(B)
Tighten the Backer Pad while
pressing shaft lock bottom.
(C)
Plug the GFCI into a power
outlet and test the GFCI for
proper operation.
Pre-start Inspection
Prior to beginning work, a pre-start inspection of the polisher should be performed.
(B)
Inspect for missing or dam-
aged components.
(C)
Test and reset the GFCI. If it
does not test and reset properly,
replace immediately.
