MJ LED LIGHTNING MJ-1350N, Руководство пользователя

Страница: 10 / 10

BEAM SPOT WASH (3IN1) 350W BEAM SPOT WASH (3IN1) 350W

Set up
Option Description
Running mode
DMX
Slave Status: Receive DMX signals from the console
or host
Self-running1 Host Status: Go and send DMX signal to slave
Voice control Pass the voice and send the DMX signal to the slave
DMX address 1~512
Press "OK" key to enter the editing state. At this time
is selected hundred, press the "up" "down" key to
change the address code. Press "OK" again to select
the ten edit. Press "OK" again to select the bit edit.
Press again to exit the editstate
Channel mode standard 20CH Standard 20CH channel mode
XReversal
turn off
open
YReversal
turn off
open
XYexchange
turn off
open
Exchange the axis of the XY axis (including fine
tuning)
XYEncoder
open
Use the encoder (optocoupler) to determine the out of
step and automatically correct the position
turn off
Do not use the encoder (optocoupler) to correct the
position
No DMX
signal
maintain Continue to run as it is
Cleared The motor is turned back and stopped
screen
protector
open Idle after 30 seconds off
turn off Backlight forever bright
Boot bright
bubble
turn off
Power on the direct reset, do not light bulb (need to
use the menu or console to manually bright bubble)
open
Power on the automatic light bubble, and to wait until
the light bulb was successfully lit.
Color wheel
linear change
open Color wheel linear change
turn off Color wheel non-linear change, half color change
Restore the
default
settings
Press the "OK" button to see the confirmation dialog
box, press the "OK" button to restore the default
settings
7

System information
Option Description
Software version current software version
DMX channel value
Thereby entering the sub-interface, displaying the channel values
in values and percentages for viewing
System error record
If the red ERR indicator light is lit, indicating that the lights run
error, the details can be entered into the sub-interface view. After
viewing, press "Clear" to clear the error log
Note: sometimes not really Hall or optocoupler installation
problems, but the motor line reverse
Total use time Accumulated use time (accurate to minutes)
This time of use This time since the start of the use of time (accurate to minutes)
The total time of the
bright bubble
Cumulative burst time (accurate to minutes)
This time the bubble
time
This bright time (accurate to minutes)

Information
Error message Description
Motor reset failed,
serial error
The driver board does not respond. There is a problem with the
serial communication line connecting the display board and the
driver board, or the drive board is faulty.
X axis reset failed X-axis photoelectric switch, or X-axis motor problem
Y axis reset failed Y-axis photoelectric switch, or Y-axis motor problem
X axis Hall error X-axis Hall has problems
Y axis Hall error Y-axis Hall has problems
Color disc reset failed Color pallet, or color plate motor problem
Pattern disk reset failed Pattern dish Hall, or pattern disk motor problem
Focus reset failed Focus on the hall, or the focus motor has a problem
Prism focus reset failed Prism focus Hall, or prismatic focus motor has problem
Lamp control failed Bright bubble or foam failure, light bulb or light bulb problems
Bright bubble time is
too long, please
change!
The accumulated light bubble time exceeds the maximum light
bubble time set in the "Advanced" menu, prompting the user to
change the gun in time. After changing the bubble in the
"Advanced" menu to clear the bright bubble time, bright bubble
time to re-count.
8