background image

 

- 5 - 

7 Climate 

The equipment has been designed for use in moderate climates and in 

domestic situations. 

 

8. Cleaning 

Unplug the unit from the mains supply before cleaning. 

The case should normally only require a wipe with a soft, lint-free cloth. Do not 

use chemical solvents for cleaning. 

We do not advise the use of furniture cleaning sprays or polishes as they can 

cause indelible white marks. 

 

9. Power sources 

Only connect the equipment to a power supply of the type described in the 

operating instructions or as marked on the equipment. 

The primary method of isolating Solo Mini from the mains supply is to use the 

switch on the rear of the unit. Solo Mini must be installed in a manner that 

makes disconnection possible. 

 

10. Power-cord protection 

Power supply cords should be routed so that they are not likely to be walked 

on or pinched by items placed upon or against them. Pay particular attention to 

the point where they exit from the equipment. 

 

11. Power lines 

Locate any outdoor antenna/aerial away from power lines. 

 

12. Non-use periods 

If the equipment is not being used for an extended period, we recommend that 

you unplug the power cord of the equipment from the outlet, to save power. 

 

13. Abnormal smell 

If an abnormal smell or smoke is detected from the equipment, turn the power 

off immediately and unplug the equipment from the wall outlet. Contact your 

dealer and do not reconnect the equipment. 

 

14. Servicing 

You should not attempt to service the equipment. 

Contact your dealer to arrange servicing. 

 

- 6 - 

15. Damage requiring service 

The equipment should be serviced by qualified service personnel when: 

A.    the power-supply cord or the plug has been damaged, or 

B. 

objects have fallen, or liquid has spilled into the equipment, or 

C.    the equipment has been exposed to rain, or 

D.    the equipment does not appear to operate normally or exhibits a marked 

change in performance, or 

E. 

the equipment has been dropped or the enclosure damaged. 

 

Safety compliance 

 

This equipment has been designed to meet the EOCENE 60065 international 

electrical safety standards. 

This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and 

(2) This device must accept any interference received, including interference 

that may cause undesired operation. 

 

WARNING:

 

 

Due to the mains switch being located on the rear panel, the apparatus must 

be located in an open area without anything obstructing access to the mains 

switch. 

Mains plug/appliance coupler is used to disconnect device and it shall remain 

readily operable. 

 

Correct disposal of this product

 

This marking indicates that this product should not be disposed with other 

household waste throughout the EU. 

To prevent possible harm to the environment or human health from 

uncontrolled waste disposal and to conserve material resources, this product 

should be recycled responsibly. 

To dispose of your product, please use your local return and collection systems 

or contact the retailer where the product was purchased. 

 

Содержание MKTP-2










Отзывы: