- 9 -
3.1 Connection
The mini series is easy to use product. Simply connect your source (CD
player, MP3 player, etc..) and speakers following below steps, you can enjoy
the high quality music in a second:
-
Connect “Line Out” mini socket (4) to the “Line In” mini socket (9) using the
supplied mini jack to mini jack audio cable.
-
Connect your CD player to the “Line In” RCA socket (5) using normal RCA
audio cable (not included)
-
Connect your speakers to the included RJ45 – binding post adapter. Then
use the provided CAT-5 cable to connect the adapter to the RJ45 jack of
the amplifier (8)
-
Connect the power adaptor to the “Power In” connector (7) of both units.
It’s now all set and you are ready to enjoy your music.
3.2 Operation
Please follow the below steps such that you can enjoy the product without any
difficulty:
-
Turn the “Volume controller” (1) clockwise to turn on the pre-amplifier and
keep the level at minimum.
Now the vacuum tube (10) will slowly turn
on and you will see blue light from the top window. Wait for around 15
seconds to let the vacuum tube warm up to its operation temperature.
-
Turn on the power amplifier using the “Power” switch (6) at the back of the
unit. Now you can see the “Power Indicator” (3) turns to blue color.
-
Play your source equipment and you can hear music from your speakers.
Now, you can control the volume level by turning the “Volume controller” (1)
-
There is a “3.5mm Headphone socket” (2) in the front panel. You can
connect your headphone to the unit. Once your headphone is connected,
the speaker output will be disconnected automatically.
-
To turn off the amplifier
, turn the “Volume controller” (1) to minimum level.
Then, switch off the “Power” switch (6) of the power amplifier. When the
“Power Indicator” (3) turn off, turn the “Volume controller” (1) to fully turn off
the pre-amplifier.
- 10 -
4. Specifications
4.1 Specification of the Power Amplifier Unit
T-Amp IC Tripath TA2024
Output Power
2x15W @4ohm
2x6W @8ohm(RMS)
Signal-to-Noise Ratio (SNR)
98dB
Dynamic Range
98dB
IHF IM Distortion
0.10% @ 1W, 4ohm
THD+Noise Audiophile Quality
0.03% @ 9W 4ohm
0.1% @ 11W 4ohm
0.1% @ 6W 8ohm
High Power
10% @ 15W 4ohm
10% @ 10W 4ohm
Power Efficiency
81% @ 15W 4ohm
90% @ 10W 8ohm
Input Audio
IN RCA (Left/Right) x 1
Power Socket
(5.5mm/2.1mm) x 1
Speaker OUT
RJ45 x1
Other
Volume & Knob Power ON/OFF switch x
Power Indicator
(Blue LED) x1
Power Supply
DC 12V-13.2V (max.)
4.2 Specification of the Headphone Amplifier Unit
Signal-to-Noise Ratio
(SNR) 92dB
Power Output
3.0 Watts per channel on 33 Ohm
Headphone
Frequency response
15 Hz - 100 kHz -1db
Input Impedance
10k Ohms
Input Audio
CD IN RCA (Left/Right) x 1 [3Vpp max.]
