16
To reset the CMOS:
1. Remove the service panel
2. Remove the jumper JPA (1) from pins 1 and 2.
3. Place jumper between pins 2 and 3 for 3 seconds (reset position).
4. Remove jumper from pins 2 and 3, and reinstall on pins 1 and 2 (the run position).
5. Reinstall the service panel or reattach the case to the display panel.
6. Reconnect the power connector and apply power. During the boot process, a
message will appear notifying the user that the CMOS and BIOS settings have been
reset to the factory defaults.
7. During the boot process, press the <F2> key to access the BIOS settings
8. Update the BIOS configuration with any appropriate user-defined requirements.
4.4
Mass Storage (M.2)
The mass storage device is a solid-state drive (SSD) with an M.2 interface in the
chassis. You need to open the cover heatsink to install it.
To replace a drive:
1. Turn off the IPC and disconnect power.
2. Remove the screws on the heat sink
3: Locate the M.2 SSD (2260) and secures the drive in the socket.
4. To install, insert the drive into the connector and secure with the hardware
previously removed.
5. Position the heat sink in place and secure with the hardware previously removed.
Thermal pads between the board and heat sink may cause resistance
when removing the service panel.
NOTE:
Failure to ensure thermal pads are properly positioned may result in performance
loss.
