OPERATIONS AFTER ENGINE IS WARMED UP
PERIODIC INSPECTION AND MAINTENANCE
2-60
2. Turn the ignition switch to the "LOCK" (OFF)
position and then connect the M.U.T.-III to the
diagnosis connector.
3. Set the timing light to the terminal No. 3 power
supply line (white) of the ignition coil No. 1.
4. Start the engine and let it run at idle.
5. Check that ignition timing is at the standard value.
Standard value: approximately 10
°
BTDC
NOTE:
.
•
The ignition timing may fluctuate within
±
7
°
.
This is normal.
•
In higher altitude, the ignition timing is more
advanced than the standard value by approxi-
mately 5
°
.
•
Wait till approximately 1 minute passes after
the engine started, and check the ignition tim-
ing when the engine stabilized.
6. Check the idle speed.
Standard value: 720
±
100 r/min
NOTE:
.
•
The idle speed is controlled automatically by
the idle speed control system.
•
When using the M.U.T.-III, select item No. 2
and take a reading of the idle speed.
7. If the idle speed is outside the standard value,
inspect the MPI system (Refer to WORKSHOP
MANUAL GROUP 13
−
Troubleshooting).
8. Remove the timing light.
9. Turn the ignition switch to the "LOCK" (OFF)
position and then disconnect the M.U.T.-III.
E6. CHECK CO CONCENTRATION
(PETROL-POWERED VEHICLES)
M6020601000769
<6G74>
1. Before inspection, set the vehicle to the
pre-inspection condition.
2. Turn the ignition switch to the "LOCK" (OFF)
position and then connect the M.U.T.-III to the
diagnosis connector.
3. Set the timing light to the terminal No. 3 power
supply line (white) of the ignition coil No. 1.
4. Start the engine and let it run at idle.
5. Check that ignition timing is at the standard value.
Standard value: approximately 10
°
BTDC
NOTE: The ignition timing may fluctuate within
±
7
°
BTDC. This is normal.
NOTE: In higher altitude, the ignition timing is
more advanced than the standard value by
approximately 5
°
.
NOTE: Wait till approximately 1 minute passes
after the engine started, and check the ignition
timing when the engine stabilized.
6. Run the engine at 2,000
−
3,000 r/min for 2
minutes.
7. Set the CO, HC tester.
AK600245AB
No.1 Ignition coil
AC807654
AB
Diagnosis
connector
MB991827
MB991824
MB991910
AK801884
No. 1 Ignition coil
AB
Содержание Pajero Sport 2013
Страница 6: ...NOTES...
Страница 16: ...BODY PRE DELIVERY INSPECTION 1 10...
Страница 17: ...BODY PRE DELIVERY INSPECTION 1 11...