Mitsubishi DX-TL930E, Инструкция по установке и эксплуатации

Страница: 9 / 77

9
ENGLISH
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Beginning
■
I/O terminals
GND terminals
The ground terminals for Input/Output terminals.
CLOCK ADJ terminal
Input terminal to set the present time display. Time dis-
play is adjusted to the nearest hour (00 minutes 00 sec-
onds) when this terminal receives the CLOCK ADJ sig-
nal.
REC terminal
Input terminal to start recording. Also use for one-shot
recording.
POWER ON terminal
Input terminal to turn on this unit through a peripheral
device.
POWER OFF terminal
Input terminal to turn off this unit through a peripheral
device.
ALARM OUT terminal
Output terminal to indicate that the alarm recording is in
process.
MODE OUT terminal
Output terminal to indicate the unit’s current mode. Se-
lect the unit’s condition by MODE OUT setting in the
<REAR TERMINAL> menu.
CALL OUT terminal / CALL OUT GND terminal
This is the ISOLATION output terminal. (Refer to page
76.) Output terminal and its GND terminal to indicate the
information such as “HDD FULL”. Select the informa-
tion by CALL OUT setting in the <REAR TERMINAL>
menu.
DC 5V OUT terminal
This terminal is for direct current voltage output. The
maximum electric current is 30mA.
*
#1
If the power cord has no earth terminal, con-
sult your dealer to replace the code (with
charge). Do not connect the earth terminal
of a plug to gas pipe, water pipe, lightning
rod and so on.