4G1 ENGINE (E–W) –
Alternator and Ignition System
11A-3-5
PWEE9520
E
Nov. 1995
Mitsubishi Motors Corporation
REMOVAL SERVICE POINT
A
A
"
CRANKSHAFT BOLT REMOVAL
(1) Lock the flywheel or drive plate in position using the special
tool shown in the illustration, then loosen the crankshaft
bolts.
INSTALLATION SERVICE POINTS
"
A
A
DISTRIBUTOR INSTALLATION
(1) Turn the crankshaft clockwise until cylinder No. 1 is at
top dead center on its compression stroke.
(2) Align the alignment marks on the distributor housing and
coupling.
(3) Fit the distributor onto the engine, aligning the stud bolts
with the slots in the distributor mounting flange.
"
B
A
CRANKSHAFT PULLEY / BOLT INSTALLATION
(1) Hold the flywheel or drive plate using the special tool.
(2) Clean the bolt hole in crankshaft, crankshaft bolt and
crankshaft pulley’s seating surface.
(3) Degrease the cleaned seating surface of the crankshaft
pulley.
(4) Install the crankshaft pulley.
(5) Apply oil to the threads of crankshaft bolt and the outer
surface of washer.
(6) Tighten the crankshaft bolt to the specified torque of 125
Nm.
"
C
A
CAM POSITION SENSOR SUPPORT
INSTALLATION
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
the area shown.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
PWEE9520-F
E
Aug. 2001
Mitsubishi Motors Corporation
Revised
MD998781
Alignment mark
Alignment mark
MD998781
Crankshaft pulley
Crankshaft
bolt
Washer
Degrease
Crankshaft
Clean
Shear-drop
Содержание 4G1 series
