Mitsubishi MOTORS Outlander Sport 2018, Руководство пользователя

Страница: 167 / 353

Multi-information display
5-104 Features and controls
5
The operation method is the same as when
the ignition switch or the operation mode is in
OFF.
For further details, refer to “Odometer/Trip
odometer” on page 5-99.
Shows the distance and number of months
until the next periodic inspection.
Refer to “Service reminder” on page 5-108.
Shows the engine coolant temperature.
If the coolant becomes hot, “ ” will blink.
Pay careful attention to the engine coolant
temperature display while you are driving.
Shows the approximate driving range (how
many more miles or kilometers you can
drive). When this driving range falls below
30 miles (50 km), “---” is displayed.
Refuel as soon as possible.
This displays the average speed from the last
reset to the present.
There are 2 types of mode settings as follows.
For details on how to change the average
speed display setting, refer to “Changing the
function settings (With ignition switch or
operation mode in ON)” on page 5-110.
 When the average speed is being dis-
played, if you hold down the multi-infor-
mation meter switch, these calculations
will be reset to zero.
 When the following operation is per-
formed, the mode setting changes auto-
matically from manual to auto.
[Except for vehicles equipped with the
F.A.S.T.-key]
Turn the ignition switch to the “ON” posi-
tion from the “ACC” or “OFF” position.
 When there is information to be announced,
such as a system fault, the tone sounds and
the screen display is switched.
Refer to “Interrupt display screen (With igni-
tion switch or operation mode in ON)” on
page 5-106.
Odometer/Trip odometer
Service reminder
Engine coolant temperature dis-
play
NOTE CAUTION

If the engine is overheating, “ ” will blink.
In this case, the bar graph is on the red zone.
Immediately park the vehicle in a safe place
and take the required measures. Refer to
“Engine overheating” on page 8-4.
Driving range display
NOTE
 The driving range is determined based on the
fuel consumption data. This may vary
depending on the driving conditions and hab-
its. Treat the distance displayed as just a
rough guideline.
 When you refuel, the driving range display is
updated.
However, if you only add a small amount of
fuel, the correct value will not be displayed.
Fill to a full tank whenever possible.

When your vehicle is stopped on an
extremely steep hill, the driving range value
may, change. This is due to the movement of
fuel in the tank and does not indicate any
breakdown.
 The display setting can be changed to the
preferred units (miles or km).
Refer to “Changing the function settings
(With ignition switch or operation mode in
ON)” on page 5-110.
Average speed display
Manual reset mode
NOTE
BK0251800US.book 104 ページ ２０１７年５月１８日 木曜日 午後２時４８分