-
18
-
'19 • SCM-SM-276
'09•SRK-DB-087D
Jumper wire (JA2)
(2)
ࠉ
Unit ON/OFF button
(a) Operation
(b) Details of operation
(3)
ࠉ
Auto restart function
(a)
(b)
(i)
(ii)
(4)
Custom cord switching procedure
(a) Modifying the indoor printed circuit board
(b) Modifying the wireless remote control
(i)
(ii)
Cut
Function
Operation mode
Room temperature
setting
Fan speed Flap/Louver Timer switch
COOL
HEAT
Unit ON/OFF button
whether to go into the COOL or HEAT modes.
room
Jumper wire (J1)
㻾㻌㻸㻌㻲㻌㻡㻌㻜㻌㻡㻌㻭㻌㻝㻌㻜㻌㻞
0
0
Unit ON/OFF button
'09•SRK-DB-087D
(2)
ࠉ
Unit ON/OFF button
(a) Operation
(b) Details of operation
(3)
ࠉ
Auto restart function
(a)
(b)
(i)
(ii)
(J170)
Function
Operation mode
Indoor temperature
setting
Fan speed Flap/Louver Timer Switch
COOL
DRY
HEAT
Unit ON/OFF button
Jumper wire (J170)
When two air-conditioners are installed in the room, use this setting when the two air-conditioners are not operated with one
wireless remote control. Set the wireless remote control and indoor unit.
(a)
ࠉ
Setting the wireless remote control
(i) Pull out the cover and take out batteries.
(ii) Disconnect the switching line next to the battery with wire cutters.
(iii) Insert batteries. Close the cover.
(b)
ࠉ
Setting an indoor unit
(i) Turn off the power source, and turn it on after 1 minute.
(ii) Point the wireless remote control (that was set according to the procedure
described on the left side) at the indoor unit and send a signal by pressing
the ACL switch on the wireless remote control.
Since the signal is sent in about 6 seconds after the ACL switch is pressed,
point the wireless remote control at the indoor unit for some time.
(iii) Check that the reception buzzer sound "Peep" is emitted from the indoor unit.
At completion of the setting, the indoor unit emits a buzzer sound "Peep".
(If no reception sound is emitted, start the setting from the beginning again.)
Disconnect
(4)
ࠉ
Installing two air-conditioners in the same room
wireless
wireless
Reception
Peep
Содержание SRK60ZSX-W
Страница 2: ......
