Mitsubishi Heavy Industries FDE112KXZE1, Техническое руководство

Страница: 139 / 156

-
138
-
'19 • KT-T-310D
Indoor unit
h
800mm
Motion sensor
Installing the motion sensor
It is possible to install the motion sensor by replacing the corner lid on the panel.
The detectable area
①
Remove the inlet grille according to the installation manual of the panel.
②
Remove the corner lid at the drain pipe side.
③
Loosen screws (2 pcs) on the control box of the unit. (It is not necessary to remove the screws.)
④
Slide the control lid in the arrow direction, and remove it.
Preparation before installation
Height of the ceiling
2.7
about 4.5
about 6.4
3.5
about 6.4
about 8.3
4.0
about 7.6
about 9.5
Detectable area
①
Detectable area
②
●
Connect the wiring to the P C B in the control box on the indoor unit and fix the wiring
securely so as not to apply unexpected stress on the P C B.
Loose connection or fixing will cause abnormal heat generation or fire.
●
Make sure the power s ource is turned off during electrical wiring work.
Otherwise, electric shock, malfunction and abnomal operation may occur.
WARNING
●
D o not leave the motion sensor without the cover.
In case the cover needs to be detached, protect the motion sensor with a packaging or bag
in order to keep it away from water and dust.
(1) Places exposed to direct sunlight
●
D o not install the motion sensor kit at the following places in order to avoid malfunction.
(2) Places near heat-generating devices
(3) High humidity places
(4) Hot surface or cold surface enough to
generate condensation
(5) Places directly exposed to oil mist or
steam
(6) Places affected by the direct air flow of
the indoor unit
(7) Places where the motion sensor may be
influenced by fluorescent lamp or sunlight
(8) Places where the motion sensor may be
affected by infrared rays of any other
communication devices
(9) Places where some object may
obstruct the motion sensor
(10) Places where there may be impact on
the motion sensor
(11) Places with strong radio wave or
static electricity
(12) Dusty place where the motion sensor
lens may become tainted or be damaged
CAUTION
Instruct the customer how to operate the motion sensor kit correctly by referring to the instruction
manual.
For the installation method of the air
-
conditioner itself, refer to the installation manual enclosed in
the package.
Attention
Accessories
Please make sure that all components are in the package.
PJF012D504
②
Drain pipe Refrigerant pipes
Installation of the motion sensor
①
Cut the half blanking (4 sections) of the panel as shown in the following figure.
②
Pass the motion sensor wiring through the opening of the panel.
③
Connect the wiring connector to CNL (3P, black) on the PCB in the control box.
④
Fix the wiring with a band as shown below.
⑤
Install the motion sensor on the panel according to the installation manual of the panel.
⑥
Install the control lid with care not to pinch the wiring, and reinstall the control lid with screws (2 pcs.).
Setting the motion sensor
The motion sensor will not function if it is only installed.
Set the function of the motion sensor by the wired or wireless remote control.
Refer to the manual instruction of each remote control for the setting procedure.
Note: It is not possible to set by the following remote control models or older ones.
Wired:RC-EX1A, RC-E5, RCH-E3
Wireless: RCN-E1R
③
④
Slide
①
②
Cut off
at 4 places
④
Hook
③
Hook