Mitsubishi Electric ZM200, Руководство по установке

Страница: 9 / 18

en
7
600 600
3
30
3
70
225 225
1050
2
8
• Be sure to install the unit in a sturdy, level surface to prevent rattling noises during
operation. (Fig. 3-1)
Foundation bolt M10 (3/8")
Thickness of concrete 120 mm
Length of bolt 70 mm
Weight-bearing capacity 320 kg
• Make sure that the length of the foundation bolt is within 30 mm of the bottom
surface of the base.
-
tions.
Installing the outdoor unit
• Do not block the vent. If the vent is blocked, operation will be hindered and break-
down may result.
• In addition to the unit base, use the installation holes on the back of the unit to
attach wires, etc., if necessary to install the unit. Use self-tapping screws (ø5 × 15
mm or less) and install on site.
Warning:
cause damage or injuries.
-
rectly installed unit may fall down and cause damage or injuries.
(mm)
pipes, to connect the refrigerant pipes. Use refrigerant pipes with the thick-
pipes are clean and do not contain any harmful contaminants such as sul-
Warning:
any other refrigerant and do not allow air to remain in the lines.
-
ards.
case, this could lead to a serious impediment to securing product safety.
Pipe size (mm) ø6.35 ø9.52 ø12.7 ø15.88 ø19.05 ø22.2 ø25.4 ø28.58
Thickness (mm) 0.8 0.8 0.8 1.0 1.0 1.0 1.0 1.0
-
M
a
x.
3
0
* When installing a single outdoor unit, the clearance is 15 mm or more.
*
Min. 500
Min. 50
M10 (3/8") bolt
Base
As long as possible.
Vent
Set deep in the ground