Mitsubishi Electric TRANE NTXCKS09A112A, Руководство по эксплуатации

Страница: 9 / 52

9
3. Operation
Reset 1
horizontal
2 3 4 5
Note:
The outlet No. is indicated by the number of grooves on both ends of
each air outlet. Set the air direction while checking the information
shown on the remote controller display.
Horizontal airflow
Downward
Outlet No.4
Electric Component box
Outlet No.1
Air outlet identification marks
Outlet No.3 Outlet No.2
Remote controller setting
The airflow direction of this outlet
is controlled by the airflow direc -
tion setting of remote controller.
Fixed
The airflow direction of this outlet is fixed
in particular direction.
* When it is cold because of direct
airflow, the airflow direction can be
fixed horizontally to avoid direct airflow.
< How to set the fixed up/down air direction >
Notes:
●
This function cannot be set depending on the outdoor unit to be
connected.
• For NTXCKS.A112A
✱
series, only the particular outlet can be fixed to
certain direction with the procedures below. Once fixed, only the set
outlet is fixed every time air conditioner is turned on. (Other outlets
follow UP/DOWN air direction setting of remote controller.)
■
Explanation of word
• “Refrigerant address No.” and “Unit No.” are the numbers given to
each air conditioner.
• “Outlet No.” is the number given to each outlet of air conditioner.
(Refer to the illustration below.)
• “Up/Down air direction” is the direction (angle) to fix.
3.5.2 Vane
<Accessing the menu>
F1 F2 F3 F4
Main
Main display:
Cursor Page
Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
<Vane setting>
F1 F2 F3 F4
Fri
Swing Off
Louver Vent. Vane
<Returning to the Main menu>
F1 F2 F3 F4
Main
Main display:
Cursor Page
Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Select "Vane·Louver·Vent.
(Lossnay)" from the Main menu
(refer to page 8), and press the
[SELECT] button.
Press the [F1] or [F2] button to go
through the vane setting options:
"Step 1", "Step 2", "Step 3", "Step
4", "Step 5", "Swing" and "Auto".
Select the desired setting.
Swing
Auto
Select "Swing" to move the vanes
up and down automatically.
When set to "Step 1" through "Step
5", the vane will be fixed at the
selected angle.
Press the [RETURN] button to go
back to the Main menu.
Step 1
Step 4
Auto
Step 2
Step 5
Notes:
●
During swing operation, the directional indication on the screen
does not change in sync with the directional vanes on the unit.
●
Available directions depend on the type of unit connected.
●
In the following cases, the actual air direction will differ from the
direction indicated on the remote controller display.
1. While the display is in “STAND BY” or “DEFROST” states.
2. Immediately after starting heat mode (while the system is wait -
ing for the mode change to take effect).
3. In heat mode, when room temperature is higher than the tem -
perature setting.
Step 3
Swing
BH79A445H01_EN.indd 9 2018/08/07 9:06:04