Mitsubishi Electric Slim Four-Way Cassette Type, Руководство по установке

Страница: 16 / 23

14
3. Drainage Elbow Installation (Cooling Only Type Without)
Fit the seal into the drain elbow, then insert the drain elbow into base pan hole of outdoor unit,
rotate 90 to securely assemble them. Connect the drain elbow with an extension drain hose
(Locally purchased), in case of the condensate draining off the outdoor unit during the heating
(Refer to Chart 30)
O
mode.
Check the drain pump whether drain water immediately when alarm sound for the high water
lever. If the water lever can't come down below to the limited water lever, the air conditioner
will stop. Restart it untill turn off the power and drain off all the water.
Turn off the power, drain the water away.
The drain plug is used to empty the water-receiver for maintenance of the air conditioner. Please
stuff it imposition at all times during operation to avoid leakage.
.
Chart 30
5
The base pan hole
of outdoor unit
The base pan
of outdoor unit
Drain elbow
Drain
elbow
Seal
Seal
1. The air conditioner should use separate power supply with rated voltage, the voltage of power
supply must be within90%~110% of rated value.
2. The external power supply to the air conditioner should have ground wiring, which is linked to
the ground wiring of the indoor and outdoor unit.
3. The wiring work should be done by qualified persons according to circuit drawing.
4. A disconnection device having an air gap contact separation in all active conductors should
incorporated in the fixed wiring according to the National wiring regulation.
5. Be sure to locate the power wiring and the signal wiring well to avoid cross-disturbance and
their contact with connecting pipe or stop valve body.
6. The wiring attached to this air conditioner is 6m long. Be sure to prolong it with wiring of the
same type and proper length if necessary. Generally, do not twist two wiring together unless the
joint is soldered well and covered with insulator tape.
7. Do not turn on the power until you have checked carefully after wiring.
8. The yellow and green wire can only be used to link to the ground wiring.
CAUTION
WIRING