44
Check Code
Abnormal points and detection method
Case
Judgment and action
E9
(6841)
Indoor/outdoor unit communication error
(Transmitting error) (Outdoor unit)
1
Abnormal if “0” receiving is detected 30
times continuously though outdoor con-
troller circuit board has transmitted “1”.
2
Abnormal if outdoor controller circuit board
could not find blank of transmission path for
3 minutes.
1
Indoor/outdoor unit connecting
wire has contact failure.
2
Defective communication circuit of
outdoor controller circuit board
3
Noise has entered power supply.
4
Noise has entered Indoor/outdoor
unit connecting wire.
1
Check disconnection or looseness of
indoor/outdoor unit connecting wire.
2
–
4
Turn the power off, and on again to
check. Replace outdoor controller cir-
cuit board if abnormality is displayed
again.
EE
Abnormal if a connection of indoor unit
and outdoor unit which uses different
refrigerant is detected.
1
Unauthorized connection of indoor
unit and outdoor unit Connections
other than below combination are
not authorized;
Outdoor unit: Models with R32 refrigerant
Indoor unit : Floor standing type
indoor unit (PSA-KA)
1
Alter the connection referring to the com-
bination as shown in the “cause” column.
EF
(6607
or
6608)
Non defined check code
This code is displayed when non defined
check code is received.
1
Noise has entered transmission
wire of remote controller.
2
Noise has entered Indoor/outdoor
unit connecting wire.
3
Outdoor unit is not a series of
power-inverter.
12
Turn the power off, and on again to
check.
Replace indoor controller board or
outdoor controller circuit board if
abnormality is displayed again.
3
Replace outdoor unit with power-inverter
type outdoor unit.
Ed
(0403)
Serial communication error
1
Abnormal if serial communication between
outdoor controller circuit board and out-
door power circuit board is defective.
1
Breaking of wire or contact failure
of connector CN2 between the
outdoor controller circuit board
and the outdoor power circuit
board
2
Breaking of wire or contact failure
of connector CN4 between the
outdoor controller circuit board
and the outdoor power circuit
board
3
Defective communication circuit
of outdoor power circuit board
4
Defective communication circuit of
outdoor controller circuit board for
outdoor power circuit board
12
Check connection of each connector
CN2 and CN4 between the outdoor
controller circuit board and the outdoor
power circuit board.
3
Replace outdoor power circuit board.
4
Replace outdoor controller circuit board.
2
Abnormal if communication between
outdoor controller circuit board and
M-NET board is not available.
1
Breaking of wire or contact fail-
ure of connector between out-
door controller circuit board and
M-NET board
2
Contact failure of M-NET board
power supply line
3
Noise has entered into M-NET
transmission wire.
1
Check disconnection, looseness, or breaking
of connection wire between outdoor control-
ler circuit board (CNMNT) and M-NET board
(CN5).
2
Check disconnection, looseness, or breaking
of connection wire between outdoor control-
ler circuit board (CNMNT) and M-NET board
(CND).
3
Check M-NET transmission wiring method.
OCH654
