17
OPERATING PROCEDURE
PHOTOS
3. Removing the heat exchanger and the compressor
(1) Remove the rear panel (2 screws in front, 1 screw on
the side, 3 screws in the rear). Remove the valve bed,
and open the rear panel to the rear to remove.
NOTE :
All panels are fixed by catches, and must be removed by
shifting up and down.
(2) Remove the 4 screws of the right side panel and
remove it.
(3) Remove the 3 screws of the rear guard and remove
the rear guard.
(4) Remove the 4 screws of the separator support plate
and remove the separator support plate .
(5) Remove the 2 screws of the motor support and
remove the motor support.
(6) Remove the 5 screws of the valve bed.
The valve bed is fixed by the catches on the right and
left sides.
Lift it to remove.
(7) Remove the electrical parts box.
Disconnect the connectors from the high pressure
switch, crank case heater, shell thermo, and fan motor
lead.
(8) Remove the 2 screws of the separator and remove the
separator.
(9) Remove the 2 screws of the heat exchanger and
remove the heat exchanger.
Detach the welded point of pipe.
(10) Remove the 3 nuts of the compressor and remove the
compressor.
Detach the welded points of the compressor suction
pipe and discharge pipe.
Photo 4
Photo 5
Photo 6
Compressor
Ball valve
Charge plug
Heat exchanger
Accumulator
Screws
Screws
OC353.qxq 05.8.9 9:27 AM Page 17