. Parts Names
n
Wireless Remote-Controller
n
Outdoor unit
Power
Earth
Service Panel
Indoor-Outdoor
Connection wire
Ref. Pipes
Transmission indicator
Timer indicator
n
When using the wireless remote controller, point it towards the receiver on the indoor unit.
n
If the remote controller is operated within approximately two minutes after power is supplied
to the indoor unit, the indoor unit may beep twice as the unit is performing the initial automatic
check.
n
The indoor unit beeps to confirm that the signal transmitted from the remote controller has
been received. Signals can be received up to approximately 7 meters in a direct line from the
indoor unit in an area 45° to the left and right of the unit. However, illumination such as fluo-
rescent lights and strong light can affect the ability of the indoor unit to receive signals.
n
If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be in-
spected. Consult your dealer for service.
n
Handle the remote controller carefully! Do not drop the remote controller or subject it to strong
shocks. In addition, do not get the remote controller wet or leave it in a location with high hu-
midity.
n
To avoid misplacing the remote controller, install the holder included with the remote controller
on a wall and be sure to always place the remote controller in the holder after use.
* For explanation purposes, all of the items
that appear in the display are shown.
* All items are displayed when the Reset
button is pressed.
Air intake
Air outlet
Remote controller display
ON/OFF button
Set Temperature buttons
Fan Speed button (Changes fan)
Check button
Mode button (Changes operation )
Airflow button (Changes up/down airflow direction
Test Run button
Transmission area
Operation areas
Timer Off button
Timer On button
Hour button
Minute button
Set Time button (Sets the time)
Louver button (Changes left/right airflow direction)
Reset button
Battery installation/replacement
1. Remove the top cover, insert two AAA bat-
teries, and then install the top cover.
2. Press the Reset button.
Top cover
Two AAA batteries
Insert the negative (–) end
of each battery first. Install
the batteries in the correct
directions (+, –)!
Press the Reset but-
ton with an object that
has a narrow end.
BG79U884H06_en.indd 5
2007/02/08 10:00:49