Mitsubishi Electric PAR-32MAA, Руководство по установке

Страница: 8 / 20

– 8 –
8
Route the wire to the top case.
9
Install the front cover and top case on the bottom case.
Two mounting tabs are at the top of the top case. (A cover is already installed on the case at the time of factory shipment.)
Hook those two tabs onto the bottom case, and click the top case into place. Check that the case is securely installed and not lifted.
• Uninstalling the front cover and top case
1
Uninstalling the front cover
Insert a flat-tip screwdriver or a Plate service
tool into either of the two latches at the bottom
of the remote controller, and move it in the
direction of the arrow as shown in the figure at
right. Note that the top case may also be
removed if the driver or the tool is inserted
deeply.
2
Uninstalling the top case
Insert a flat-tip screwdriver or a Plate service
tool into either of the two latches at the bottom
of the remote controller, and move it in the
direction of the arrow as shown in the figure at
right.
Hold the cables in place with clamps to prevent undue force from
being applied to the terminal block and causing cable breakage.
Important
Clamp
Insert the wire.
When attaching the cover and the top casing to the bottom casing,
push it until it they click into place.
If they are not properly locked into place, they may fall, causing
personal injury, controller damage, or malfunctions.
Important
■
Direct wall installation (when running the cable along the wall)
• Thread the cable through the access hole at the top of the
remote controller.
• Seal the cut-out part of the cover with putty.
• Use a cable cover.
Installation is complete.
Follow the instructions below when uninstalling them.
No lifting
Wall
Seal the gap with putty.
Use a cable cover.
Thread the cable through the
top of the remote controller.
or
or
Wall Wall
WT08394X01_GB_A5.book 8 ページ ２０１６年９月２６日 月曜日 午後７時１４分