English
EN-4
Screw
Screw
Screw
1-
7/
8"
(4
8)
3-1
/1
6"
(7
8)
Screw
Relay
connector
Hook
Hook
Upper case
Lower case
Screw
Cable from the connecting devices
(Wireless Interface, USNAP Interface,
or Equipment Controller)
Relay connector connection cable
Length: 590-9/16" (15,000)
Indoor unit connection cable
Length: 64-31/32" (1,650)
Unit: inch (mm)
3–1–2. Installing the IT Extender
indoor unit
Screw
Screw
Screw
Screw
Mounting cord
clamp
Connecting
cable (5-wire)
1) Connect the cable from the connecting device (Wireless
Interface, USNAP Interface, or Equipment Controller)
to the Relay connector of the IT Extender.
2) Place the connected connector inside the lower case ,
and wind the cable (of USNAP Interface or Equipment
Controller) *¹ around the hooks in the lower case , so
that the unsheathed part of the cable stays inside the
lower and upper cases.
*1: Do not wind the cable of Wireless Interface.
3) Close and affix the upper case and lower case with
2 screws .
4) Use the screws , , to install to the wall.
Notes:
● Avoid routing cables around metal surface.
● Do not route cables near noise sources such as motors.
● Corporate Logo can be upside down depending on the
installation direction of IT Extender.
If you are eager to reverse it, remove the case of IT Extender
and attach it again in an inverted position.
● Remove 2 screws from the back side of
IT Extender and remove the case.
● Do not touch the cables inside the IT Extender.
● If the cables come off IT Extender, stow them as shown
in the photo on the below.
Removing case of IT Extender
Caution
Back side of
IT Extender
BH79A352H01_en.indd 4
6/16/2017 8:50:59 AM