
English
EN-3
Parts Name
Q’ty
Parts Name
Q’ty
IT Extender
1
Screw for fixing
Case for connector
connection (4×30)
2
Upper Case for
connector connection
1
Mounting cord clamp
3
Lower Case for
connector connection
1
Mounting cord clamp
fixing screw (4×30)
3
IT Extender fixing
screw (4×30)
2
Screw for fixing upper
case and lower case
(3×8)
2
2. Parts
3. Installation
The IT Extender should be supplied with the following parts.
3–1. Installation
3–1–1. Choosing the IT Extender installation location
● Do not install the IT Extender in outdoor location.
(The IT Extender circuit board and casing are not waterproof.)
● Avoid locations where the IT Extender is exposed to direct sunlight or other sources of heat.
● Avoid locations where combustible gases may leak, be produced, flow, or accumulate.
● Select a level location that can bear the weight of the IT Extender.
● Avoid locations where the IT Extender is exposed to oil, steam, or corrosive gases.
● Do not install in location that ambient temperature exceeds 104°F (40°C) and relative humidity exceeds 80%.
● Do not install IT Extender on top of the indoor unit.
● Depending on the installation, or the type of the wall or post; the accessory screw may not be long enough. In
that case, please procure an appropriate screw locally.
The installation direction is limited when installing on a wall.
Correct installation direction
Install the IT Extender so that the cables
extend out from either side (left and right),
as illustrated.
When installing on the wall, do not place
the devices in the manner shown on the right.
Doing so may cause electric shock or fire.
Warning
Unit: mm
BH79A352H01_en.indd 3
6/16/2017 8:50:59 AM