Mitsubishi Electric PAC-TZ02-E, Руководство по обслуживанию

Страница: 13 / 16

13
OCH729
DISASSEMBLY PROCEDURE PHOTOS/ FIGURES
7. How to detach and attach the quick connection
Refer to the following steps when detaching and attaching
the quick connection.
(1) Remove the clip (Photos 7-1 and 7-2).
(2) Separate the connected parts to remove the O-ring
(Photo 7-3).
• Do not reuse the removed O-ring.
• Wipe off if dirt or foreign matters are found on the seal-
ing surface where the O-ring touches.
(3) Apply grease on the O-ring using a plastic bag, etc.
(Photo 7-4)
(4) Attach the O-ring to the male part of quick connection.
(Photo 7-5)
• Keep the O-ring free from dirt or foreign matters.
(5) Connect the male and female parts of the quick connec-
tion. (Photo 7-6)
(6) Attach the clip. (Photo 7-7)
• Ensure to attach the wider diameter of the clip to the
female side. Failure to do so it may cause water leak at
the connected part. (Photo 7-8) (For the same diame-
ter quick connection, following this note is not neces-
sary.)
Photo 7-1
Photo 7-2
O-ring
Plastic
bag
Female Male
O-ring
Photo 7-3
Photo 7-4 Photo 7-5
Photo 7-6 Photo 7-7 Photo 7-8
Clip
Clip
Gap
Clip