Mitsubishi Electric PAC-SC30GRA, Руководство по установке

Страница: 24 / 35

16
2
Select the unit
(1) Select the unit to be registered in the group selected with
1
.
• The address numbers will change in the sequence shown below within the temperature setting
display area whenever the temperature setting switch is pressed.
” “
• • • •
” “ ” “ ” “
• The address numbers will change in the opposite direction when the switch is pressed.
Temperature setting display area: Address number displayed
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
ON
˚C
NOT AVAILABLE
˚C
OFF
GROUP
CHECK
FILTER
CHECK MODE
TEST RUN
ADDRESS
(2) Selecting registered units
• The following display will be shown when the selected unit is registered in one of the eight groups
controlled by this equipment.
Example:
When unit 011 is called out with group 3
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
ON
˚C
NOT AVAILABLE
˚C
OFF
GROUP
CHECK
FILTER
CHECK MODE
TEST RUN
ADDRESS
Cursor blinks. Indicates that the unit is registered in group 6 in this case.
3 To register units in groups
(1) Register the selected units in groups
• Press the TEST RUN switch with the group number and unit address selected with
1
and
2
displayed.
• This operation completes the registration task.
• [
] or unit type will be displayed if registration was performed normally. [ ] will blink beside the
unit type if the registration was not performed normally.
Display the address number that is to be registered
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
ON
˚C
NOT AVAILABLE
˚C
OFF
GROUP
CHECK
FILTER
CHECK MODE
TEST RUN
ADDRESS
(2) Registering other units
• The subsequent address will be displayed when the temperature setting switch is pressed
after registration is complete. Repeat procedures 2 and 3 to continue with registration.
NOTE: Registration is required not only for indoor units but when you want to set the remote controller
and slave system controller as well. Registration of multiple groups is possible only at the system
controller address.
Each controller Indoor unit: IC
Remote controller: RC
System controller: SC
Indoor unit: 001 to 050
Remote controller: 101 to 200
System controller: 201 to 250
[ ] or unit type will be displayed if
registration was performed normally
Registration complete screen. Indoor unit with an
address number of 006 is registered in group 3.