39
OPERATING PROCEDURE
PHOTOS
3. Removing propeller and the outdoor fan motor
(1) Remove the cabinet (Refer to 1.).
(2) Remove the propeller nut and remove the propeller.
NOTE:
Loosen the propeller in the rotating direction for removal.
When attaching the propeller, align the mark on the
propeller and the motor shaft cut section.
(3) Disconnect the connector and remove the lead clamp and
outdoor fan motor lead wires.
(4) Remove the screws fixing the outdoor fan motor.
(5) Remove the outdoor fan motor.
Photo 4
4. Removing the compressor
(1) Remove the cabinet (Refer to 1.).
(2) Remove the relay panel.
(3) Remove the soundproof felt.
(4) Remove the terminal cover on the compressor.
(5) Disconnect lead wires from the compressor.
(6) Recover gas from the refrigerant circuit.
(7) Disconnect the brazed part of the discharge pipe.
(8) Disconnect the brazed part of suction pipe.
(9) Remove nuts fixing the compressor.
(10) Remove the compressor.
NOTE
• Before using a burner, recover gas from the pipes until the
pressure gauge shows 0 kg/cm
2
(0 MPa).
• Use the burner under the condition that gas can be
recovered even when the inner pressure rises by heat.
Photo 5
Set screws of the
outdoor fan motor
Propeller nut
Propeller
Set screws of the
outdoor fan motor
Brazed part of the
suction pipe
Brazed part of the
discharge pipe
Compressor
set nuts
OBH622A