En-5
● OPERATING INSTRUCTIONS ●
ABSENCE DETECTION
This function automatically changes the operation to energy-saving operation
when nobody is in the room.
I
-SEE OPERATION
1
To activate this function, press
until
appears
on the operation display of the remote controller.
2
Press
again to release ABSENCE DETECTION.
INDIRECT/DIRECT mode
The INDIRECT/DIRECT mode offers fi nely-tuned operation by locating where
an occupant is in the room.
1
Press
during COOL, DRY, HEAT or AUTO
mode to activate the INDIRECT/DIRECT mode. This
mode is only available when the i-see control mode is
effective.
2
Each press of
changes INDIRECT/DIRECT in
the following order:
(INDIRECT) : An occupant will be less exposed to
direct airfl ow.
(DIRECT) : Mainly the vicinity of an occupant will
be air-conditioned.
• Horizontal and vertical airflow directions will be automatically select-
ed.
• When more than a couple of people are in a room, the INDIRECT/DI-
RECT mode may work less effectively.
• If you still feel uncomfortable with the air direction determined by the
INDIRECT mode, adjust the air direction manually.
Page
7
3
Canceling the i-see control mode automatically cancels
the INDIRECT/DIRECT mode.
• The INDIRECT/DIRECT mode is also cancelled when the VANE or
WIDE VANE buttons is pressed.
Note:
•
Do not touch the i-see sensor. This may cause malfunction of the i-see sen-
sor.
• The intermittent operating sound is a normal sound produced when the i-see
sensor is moving from side to side.
Press
during COOL, DRY, HEAT and AUTO mode
to activate the i-see control mode.
• Press gently using a thin instrument.
•
lights. (Operation display section)
• The default setting is “active”.
Press
again to activate ABSENCE DETECTION.
•
lights. (Operation display section)
Press
again to release the i-see control mode.
1
2
3
i-see control mode
In the i-see control mode, the room temperature is controlled based on the
sensible temperature.
(INDIRECT) (DIRECT)
(OFF)
SG79F661H02_en.indd 5
2012/12/18 (火) 午後 1:28:15