Mitsubishi Electric MSY-GS07VF, Руководство по эксплуатации

Страница: 8 / 48

En-7
● OPERATING INSTRUCTIONS ●
Note:
• Press
CLOCK
gently using
a thin instru-
ment.
Note:
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batter-
ies. The remote controller could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the
battery is running low. In about 7 days after the indica-
tor starts lights up, the remote controller stops work-
ing.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. How-
ever, batteries with expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET is not pressed, the remote controller
may not operate correctly.
Before operation: Insert the power supply plug into the
power outlet and/or turn the breaker on.
Installing the remote control-
ler batteries
Setting current time
1.
Press
CLOCK.
3.
Press CLOCK
again.
1.
Remove the
front lid.
2.
Insert the
negative pole
of AAA alkaline
batteries fi rst.
3.
Install the front lid.
4.
Press RESET.
2.
Press the TIME
buttons to set the
time.
Each press
changes the clock
1 minute forward/
backward (10 min-
utes when pressed
longer).
Note:
How to set remote controller exclusively for a par-
ticular indoor unit
A maximum of 4 indoor units with
wireless remote controllers can
be set.
To operate the indoor unit individ-
ually with each remote controller,
assign a number to each remote controller according to
the number of the indoor unit. Please set according to
the following procedure:
(1) Turn the breaker OFF for the unit.
(2) With the remote controller powered
OFF, hold down UNIT on the remote
controller for 2 seconds to enter the
pairing mode.
Setting number is displayed in the
remote controller.
(3) Press UNIT again and assign a number to each
remote controller.
Each press of UNIT advances the number in the
following order: 1→2→3→4.
(4) Press to complete the pairing setting.
After you turn the breaker ON, the remote controller that
fi rst sends a signal to an indoor unit will be regarded as
the remote controller for the indoor unit.
Once they are set, the indoor unit will only receive the
signal from the assigned remote controller afterwards.
The setting of indoor unit will be cancelled, if the breaker
is turned OFF or the power supply is shut down.
P
REPARATION BEFORE OPERATION
A5_JG79Y754H01_01En.indd 7 2020/06/02 10:06:56