35
11-1. MS-GF20VA MS-GF25VA MS-GF35VA
NOTE:
Turn OFF power supply before disassembly.
OPERATING PROCEDURE
PHOTOS
1. Removing the panel
(1) Remove the horizontal vanes.
(2) Remove the screw caps of the panel. Remove the
screws of the panel.
(3) Unhook the lower part ( ) of the panel.
(4) Hold the lower part of both ends of the panel and pull
it
slightly toward you, and then remove the panel by
pushing it upward.
Photo 1
(1) Slide the sleeve and check if there is a locking lever or not.
(2) The terminal with this connector has the
locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
Sleeve
Locking lever
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
Screws of the panel
Front panel
Horizontal vanes
A
DISASSEMBLY INSTRUCTIONS
11
OBH621A
