21
(3) Positioning
The vane is once pressed to the vane stopper to confirm the standard position and then set to the desired angle.
Confirming of standard position is performed in case of follows.
(a) When the OPERATE/STOP(ON/OFF) button is pressed (POWER ON/OFF).
(b) When the operation mode is changed.
(c) When the power supply turns ON.
(4) SWING MODE (
)
By selecting SWING mode with the WIDE VANE button, the horizontal vane swings vertically. The remote controller dis-
plays “
”. The vane moves right and left in the width of Angle 4 repeatedly.
(5) WIDE MODE (
)
By selecting WIDE mode with the WIDE VANE button, indoor fan speed becomes faster. The remote controller displays
“
”.
NOTE : The position of vane angle 3, angle 4 and angle 5 are different in COOL operation and FAN operation.
(3) Press ON/OFF TIMER button to select the operation.
ON-TIMER button... AUTO START operation (ON timer)
OFF-TIMER button... AUTO STOP operation (OFF timer)
(4) Press HR. and MIN. button (TIME set button) to set the timer. Time setting is 10-minute units.
HR. and MIN. button will work when “
” or “
” mark is flashing.
These marks disappear in 1 minute.
After setting the ON timer, check that OPERATION INDICATOR lamp of the indoor unit lights.
NOTE1 : Be sure to place the remote controller at the position where its signal can reach the air conditioner even during
TIMER operation, or the set time may deviate within the range of about 10 minutes.
NOTE2 : Reset the timer in the following cases, or the set time may deviate and other malfunctions may occur.
●
A power failure occurs.
●
The circuit breaker functions.
8-7. TIMER OPERATION
1. How to set the timer
(1) Press OPERATE/STOP(ON/OFF) button to start the air conditioner.
(2) Check that the current time is set correctly.
NOTE : Timer operation will not work without setting the current time. Initially “AM0:00” blinks at the current time display
of TIME MONITOR, so set the current time correctly with CLOCK SET button.
About 100
-
Horizontal AIR FLOW blowing range
PROGRAM TIMER
(Example 1) The current time is 8:00 PM.
The unit turns off at 11:00 PM, and on at 6:00 AM.
●
The OFF timer and ON timer can be used in combination.
●
“
” and “
” display shows the order of the OFF timer and ON timer operation.
PM
AM
(Example 2) The current time is 11:00 AM.
The unit turns on at 5:00 PM, and off at 9:00 PM.
PM
PM
2. Cancel
TIMER setting can be cancelled with the ON/OFF TIMER buttons.
To cancel the ON timer, press the ON-TIMER button.
To cancel the OFF timer, press the OFF-TIMER button.
TIMER is cancelled and the display of set time disappears.
NOTE : TIMER setting will be cancelled by power failure or breaker functioning.
OB255--1qxp 7/20/00 10:09 AM Page 21
