15
Be sure to connect the remote
locations shown in the diagram.
Secure with a band
location shown in the diagram
Secure with a band
at the location shown in the
diagram
(Remote controller
Cable strap
12
CN5Y
CN90
CN4Z
Electric component cover
Electric component box
Entry for Indoor-Outdoor connecting cable
Entry for wired remote controller cable
Cable clamp
Indoor controller
Earth cable
Cable strap
1. Loosen the two screws securing the electric component cover, and then slide and
remove the cover.
2. Route the wires along the wiring routes and through the wire inlets in the electric
component box.
cable to the terminal block.
4. Secure the wires with the cable straps inside the electric component box.
Secure the wires with cable straps as cushioning components so that no stress is
applied to the connecting sections of the terminal block when tension is generated.
5. Install the electric component cover.
Make sure that the wires do not get pinched.
6. Secure the wires with the cable straps outside the electric component box.