En-9
●
OPERATING INSTRUCTIONS
●
F
AN SPEED AND AIRFLOW
DIRECTION ADJUSTMENT
Operation indicator lamp
Emergency operation
When the remote controller cannot be used...
Emergency operation can be activated by pressing the
emergency operation switch (E.O.SW) on the indoor unit.
Each time the E.O.SW is pressed, the
operation changes in the following order:
Auto restart function
If a power failure occurs or the main power is turned off
during operation, “Auto restart function” automatically starts
operation in the same mode as the one set with the remote
controller just before the shutoff of the main power. When
timer is set, timer setting is cancelled and the unit starts
operation when power is resumed.
If you do not want to use this function, please consult
the service representative because the setting of the
unit needs to be changed.
Set temperature : 24°C
Fan speed : Medium
Horizontal vane : Auto
Note:
The
fi
rst 30 minutes of operation is
test run. Temperature control does not
work, and fan speed is set to High.
Emergency COOL
Stop
Press
to select fan speed. Each press
changes fan speed in the following order:
(AUTO) (Low) (Med.) (High)
(Super
High)
• Two short beeps are heard from the indoor unit
when set to AUTO.
Press
to select vertical airflow direction.
Each press changes airflow direction in the fol-
lowing order:
(AUTO) (1)
(2)
(3)
(4)
(5) (SWING)
• Two short beeps are heard from the indoor unit
when set to AUTO.
Press
to select horizontal air
fl
ow direction.
Each press changes air
fl
ow direction in the follow-
ing order:
(SWING)
Operation indicator lamp
Emergency COOL
<GS18/24>
<GS30/36>
Stop
01_VG79Y359H01_EN.indd 9
01_VG79Y359H01_EN.indd 9
23/6/21 10:11
23/6/21 10:11
