4
From Installation to Operation
Installation area
At least 2cm from the
left and right sides.
adjustable
support
caster
Leave space
between items in
the refrigerator.
Avoid opening and closing
the door unnecessarily and
leaving the door open for a
long time.
Use your refrigerator efficiently
to save electricity
Frost build-up can cause
decline in cooling ability as
a result of even the
slightest door
opening
Be sure not to
catch food items,
plastic bags,
power chords,
etc. in the door
when you close it.
The installation area should be unexposed to
direct sunlight and hot air, and be well-ventilated
to avoid diminished cooling power and to economize on cost of electricity
It should have little humidity
to prevent rusting
It should be strong and level
to prevent vibration and noise
●
Install a strong plate or board under flooring on which the
refrigerator legs easily sink (such as carpeting, tatami, polyvinyl
chloride flooring, etc.). (For prevention of deformation or
discoloration due to heat)
It should be far from the TV
to prevent the cause of noise or interference to the images on the TV
Leave space for heat ventilation
Leave at least 2cm of space on the right and
left and 10cm of space between the ceiling
and the top of the refrigerator
to allow heat to escape from the ceiling and the sides of the refrigerator
Heat builds up in exterior walls of the refrigerator
When the refrigerator is first used and during the summer heat
build-up can exceed 50-60˚C
Warning
Do not close the ventilation hole of the refrigerator or the crack
around the refrigerator.
If the refrigerant leaks, ignition or explosion may be caused.
Electrical Connections
Make sure this unit is properly grounded.
●
The unit should always be plugged into its own electrical outlet.
This will provide the best performance and prevent electrical
circuits from being overloaded and causing a fire.
Make sure that the electrical outlet provides the proper voltage.
Extension cords are not recommended.
●
Connect the ground wire to the ground connection screw
provided at the lower, rear side of this unit.
●
If your unit is installed in the high humidity location, not only
ground connection but also installation of the earth leakage
breaker is recommended.
●
If the power cord is damaged, purchase a new cord from
MITSUBISHI SERVICE CENTER. Make sure that the power
cord is designed for this model.
●
If the power cord is damaged, call our MITSUBISHI SERVICE
CENTER for the replacement, in order to avoid a hazard.
About Non-Freon Refrigerator
Do not damage the refrigerant circuit or the pipes nor
mount anything with screw.
Non-Freon Refrigerants are flammable gas. However,
it is hermetically-sealed, therefore, leaking is infrequent.
Warning
Just in case of having damaged the refrigerant circuit.
1. Do not use electric items or fire equipments near by.
2. Open the window and ventilate the room.
Please contact the retail store at which you purchased it
or a Mitsubishi Electric Maintenance Service or Customer
Service representative.
F
rom Installation to Oper
ation
Door alarm
If the refrigerator or ice-
making doors are open for
more than one minute, an
alarm will beep, notifying the
user that cold air is escaping
PU8>M;9=g895996x>=
06.5.24, 5:01 PM
4
Содержание MR-G50J
Страница 30: ...MEMO ...
Страница 31: ...MEMO ...
