English-49
English
OSD screen functions (continued)
ADVANCED OPTION
"
INPUT RESOLUTION
* For the RGB3 and RGB4 inputs only.
You can select the following resolutions according to
the input signal: AUTO, 1024x768, 1280x768, 1360x768,
1366x768, 1400x1050, 1680x1050, 1600x1200, and
1920x1200. AUTO selects the resolution automatically.
The setting you select becomes effective when POWER is
turned OFF and ON again.
"
BLACK LEVEL EXPANSION
Selects a level of black expansion from “OFF”, “MIDDLE”
and “HIGH.”
In case of go under the black cut-off level, please adjust the
“Black level” in moderation on OSD menu.
"
INPUT CHANGE
You can select the time for input switching from QUICK and
NORMAL.
NOTE: When you select QUICK, slight noise may appear.
"
SCAN MODE
* For the RGB1 (HDMI), DVD/HD, VIDEO<S>, and VIDEO
inputs only.
You can select the image display area.
OVERSCAN: About 95% of the input image is displayed.
UNDERSCAN: Almost 100% of the input image is
displayed.
"
SCAN CONVERSION
* For the RGB1 (HDMI), DVD/HD, VIDEO<S>, and VIDEO
inputs only.
You can select the IP conversion mode.
PROGRESSIVE: Interlace signals are converted into
progressive signals. Select this setting for
normal cases.
INTERLACE:
Interlace signals are displayed without
being converted. Though this setting is
suitable for motion images, still images
aren’t displayed properly.
"
FILM MODE
You can select the fi lm mode function.
AUTO: Images of 24 frames per second are detected,
subjected to interpolation, and then displayed.
OFF:
The input video signals are displayed without being
subjected to any processing.
NOTE: When FILM MODE is AUTO, set SCAN CONVERSION
to PROGRESSIVE. See page 49.
"
IR CONTROL
You can lock the wireless remote control.
Select from the following two modes using the and
buttons and then determine the selected mode by pressing
the SET button.
NORMAL:
All the remote control operations are
enabled.
PRIMARY:
The fi rst MDT651S monitor of those multi-
connected via RS-232C is designated as
PRIMARY.
SECONDARY: MDT651S monitors other than the fi rst
one multi-connected via RS-232C are
designated as SECONDARY.
LOCK:
All the remote control operations are
disabled.
NOTE: When you hold down the DISPLAY button on the
wireless remote control for at least 5 seconds, the
NORMAL mode is activated.
You can lock the wireless remote control
independently from the control buttons on the rear
of the monitor. See page 51.
"
TILING
You can enlarge an image across multiple screens.
A single large screen can be confi gured with up to 25
monitors. You can also divide the displayed image into up
to 5 pieces horizontally and vertically.
NOTE: It is required to connect the same video signal to
each monitor via a distributor or RGB OUT.
When TILING is activated, PIP, POP, SBS, and STILL
are disabled.
TILING doesn’t work in the REAL picture size mode.
H MONITORS: Select the number of images obtained by
horizontal division.
V MONITORS: Select the number of images obtained by
vertical division.
POSITION:
Select the area you want to enlarge.
FRAME COMP.: When displaying an image across multiple
monitors, you can select the mode to
compensate for the bezel widths for
smooth and natural display.
ENABLE:
When you select ON, the image in the
selected area is enlarged on the screen.
