Air
volume
Normal
Night
Turbo
9
Before Use
Select from Manual operation (five air volume levels), Auto operation (Normal, Night and Turbo).
Insert the power plug into the power outlet.
Insert the power plug, wait for the “blip” sound, and then press the operation On/Off switch.
(If operation does not start after pressing the operation On/Off switch, press it again.)
1
Start operation.
Blip
Press
l
The operation starts or stops each
time you press the switch.
l
An operation mode lamp lights up.
l
The triple clean monitor lamps
light up.
Response will be slow for a few minutes
after the operation On/Off switch is turned
ON because the PM2.5 Sensor and odor
sensor are performing the preparation
operation.
2
Change the operation.
For operation with a constant air volume (Manual)
Press
l
Each press changes
the air volume, and
the lamp for the
selected air volume
lights up.
Press
l
Each press changes
the operation mode,
and the lamp for the
selected operation
mode lights up.
Low
High
For automatic operation depending on the contamination in the air (Auto)
This is the standard automatic operation.
The air volume is changed automatically.
Operation is performed automatically while
keeping the air volume low.
(The brightness of the lamps on the control panel
and the monitor lamps are dimmed slightly.)
Operation is performed automatically with the
maximum air volume.
To end operation
Bleep
Press
l
The operation mode lamp goes out.
l
The triple clean monitor lamps go
out.
The operation mode is remembered even if the
operation On/Off switch is turned OFF or the
power plug is disconnected.
Operation
Operation
en_ma-a85r-a_cs55.indd 9
2021/10/20 13:11:15